1500W PTC Fast Heating Space Heater for Indoor Use

My old heater died and I needed a new one. This one has a thermostat so I can set it to a temperature I want for my small bedroom and it shuts down by itself. It is not loud at all. It looks very sleek and very energy efficient compared to my old heater. I am really happy I tried something new.

I just got this heater and its a pretty good one. I have gotten a mini heater before but it ended up causing noise. this one can heat up tp about 90 degrees which is more sufficient, has a timer, and very quiet. It also comes with controller which is blue especially if you're considering slowing with it connected. It hasn't caused any problems yet, And it warms up a room within a mins. I like it and recommend it

I have been waiting for a while to get this and now that I have it I am so thankful. The weather has turned cold and this came just in time! When you get this you have some small assembly of the stand. First thing to take notice of when you take out the stand half's is that one of the stand half's have a small package of 4 screws in the sack. Watch for them! Don’t loose them! The package is small and could easily get thrown away. The instructions for putting the stand together are a little bewildering so my recommendation is look at the pictures and look at the 2 stand half's before you try to snap them together. Make sure you have the power cord properly placed before you do anything with the stand as this has to go through the middle of the stand. I lined up one of the stand half's on the bottom of the unit with the 2 holes in the unit and screwed it in. Then I carefully snapped the other stand half together to form the full circle of the stand. This does not snap together real easily so take your time as to not break or snap a piece of plastic. Like I said carefully look at the stand before assembly so you can see exactly what you have to do before assembly. Once you get the other half of the stand snapped together then screw the 2 remaining screws into that stand and it should be aligned with the holes in the unit perfectly if you installed the first half of the stand first. The unit stands 30 inches tall and the power cord is a little over 5 feet at 69 inches long. This heater has a nice little flame light on it that you can turn off or on. All the controls are on the top of the unit and also on the remote. The remote takes 2 triple A batteries not included. This unit will blow cold air too and can blow hot air in a low and high mode. The heat can be controlled as far as the temp from 62-95 degrees. It also will give you a readout of the room temperature on the display. You can turn on or off the rotating feature too. The heating of the room is more efficient if you have it rotate back and forth. On the back of the unit there is a nice cord wrap protruding plastic piece for storage. Also on the back is a handle at the top for carrying and storing the remote. This is a real nice unit. The only thing I kind of wished it had was a flicker on the flame light when it’s on. The other feature this unit has is a timing feature to have it run from 1-12 hours. A very nice, not to large footprint room heater that works very well.

I really like this electric heater. It can rotate 365 degrees and can adjust the temperature by itself. It is small enough that it does not take up a lot of space and is very practical.

Wow wow wow wow! It was way better than I expected and it was so easy to set up. It came with a remote control and a few settings to choose from!